Zanussi ZRG16606WA Benutzerhandbuch

10. Tighten the hinge.

11. Put the top in position.

12. Push front the top.

13. Screw both screws on the rear side.

14. Remove and install the handle on the

opposite side.

Do a final check to make sure that:

• All screws are tightened.

• The magnetic seal adheres to the

cabinet.

• The door opens and closes

correctly.

If the ambient temperature is cold

(i.e. in Winter), the gasket may not fit

perfectly to the cabinet. In that case,

wait for the natural fitting of the

gasket.

In case you do not want to carry out

the above mentioned operations,

contact the nearest Authorised

Service Centre. The Authorised

Service specialist will carry out the

reversibility of the doors at your cost.

Any electrical work required to install

this appliance should be carried out

by a qualified electrician or

competent person.

This appliance must be earthed.

The manufacturer declines any

liability should these safety

measures not be observed.

The wires in the mains lead are coloured in

accordance with the following code:

• A - green and yellow: Earth

• C - brown: Live

• D - blue: Neutral

As the colours of the wires in the mains lead of

this appliance may not correspond with the

coloured markings identifying the terminals in

your plug, proceed as follows:
1. Connect the wire coloured green and

yellow to the terminal marked either with the