Zanussi ZRG16606WA Benutzerhandbuch

The door has been opened of-

ten.

Open the door only if necessary.

There is no cold air circulation

in the appliance.

Make sure that there is cold air cir-

culation in the appliance.

If the advice does not lead to the

desired result, contact the nearest

Authorised Service Centre.

Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.

2. Remove the lamp cover (refer to the

illustration).

3. Replace the used lamp with a new lamp of

the same power and specifically designed

for household appliances (the maximum

power is shown on the lamp cover).

4. Install the lamp cover.

5. Tighten the screw to the lamp cover.

6. Connect the plug to the mains socket.

7. Open the door.

Make sure that the light comes on.

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective door

gaskets. Contact the Authorised Service

Centre.

Refer to Safety chapters.

This appliance can be installed in a dry, well

ventilated indoor where the ambient

temperature corresponds to the climate class

indicated on the rating plate of the appliance:

SN

+10°C to + 32°C

N

+16°C to + 32°C

ST

+16°C to + 38°C

T

+16°C to + 43°C

Some functional problems might

occur for some types of models

when operating outside of that

range. The correct operation can

only be guaranteed within the

specified temperature range. If you

have any doubts regarding where to

install the appliance, please turn to

the vendor, to our customer service

or to the nearest Authorised Service

Centre.

You can find the two spacers in the bag with

documentation.
1. Release the screw.

2. Engage the spacer below the screw.

3. Turn the spacer to the right position.

4. Tighten again the screws.