Sony pdw-f30 Benutzerhandbuch

38

Recording

  

Ch
apt

er 3  Rec

o

rdi
ng and

 P

la

y

bac

k

This section describes video and audio recording on the 
unit.

See page 75 “Function Menu” in Chapter 6 for more 
information about function menu operations.

See page 86 “Setup Menu Operations” in Chapter 6 for 
more information about setup menu operations.

It is not possible to combine material recorded in different 
system frequencies and audio recording formats on a 
single disc (although different bit rates may be combined). 
If you attempt to record material in a system frequency or 
audio recording format that differs from that of existing 
recorded material on the disc, “REC INH” appears on the 
display and recording is inhibited.

Make the following settings and adjustments before 
starting to record.
Recording format settings: See the next section “To set 

the video and audio recording formats”.

Timecode and user bits settings: See “Recording 

Timecode and User Bit Values” (page 38).

Selection of time data to display: Select with CNTR SEL 

on the HOME page of the function menu.

Selection of audio channels to monitor: Select with 

MONI CH and MONI SEL on the HOME page of the 
function menu.

Volume adjustment of the monitor audio: Adjust with 

the LEVEL knob.

Remote/local setting: Set the remote control switch. If 

you set it to REMOTE, also set the setup menu item 
INTERFACE SELECT >REMOTE I/F (“REMOTE” 
and the connector used appear on the display).

To set the video recording format
Set the video bit rate (compression method) by setting 
OPERATIONAL FUNCTION >REC FORMAT in the 
setup menu to one of the following.

To set the audio recording format
Set AUDIO CONTROL >REC MODE in the setup menu 
to one of the following.

There are the following four ways of recording timecode:
Internal Preset mode: This records the output of the 

internal timecode generator, set beforehand to an 
initial value. The following run modes can be 
selected.
• Free Run: Timecode advances continually.
• Rec Run: Timecode advances only during 

recording.

Internal Regen mode: This records the output of the 

internal timecode generator, initialized to timecode 
following continuously upon the timecode of the last 
frame of the last clip on the disc.

Make the following settings in the function menu.

• Set CNTR SEL on the HOME page to “TC”.
• Set TC MODE on page P1 to “PRESET”.

Press the DISPLAY button to maximize the monitor 
video section.

Press the MENU button.

The system menu appears on the display.

Select “TC PRESET” using the 

M/MARK1 button or 

m/MARK2 button, then press the ,/OUT button.

HQ

VBR 35 Mbps

SP

CBR 25 Mbps

LP

VBR 18 Mbps

2ch×16bit

2CH 16BIT

2 channels/16 bits

4ch×16bit

4CH 16BIT

4 channels/16 bits