Lantronix LX6 Benutzerhandbuch

The XPort Pro Lx6 embedded device server contains one line using a standard RS232/RS485 
serial port.  This line may be configured to operate in the following modes:



RS232



RS485 Full Duplex (also compatible with RS-422)



RS485 Half Duplex, with and without termination impedance



All serial settings such as Baud Rate, Parity, Data Bits, etc, apply to these lines.

The Line Settings allow configuration of the serial lines (ports).

Some settings may be specific to only certain lines.  Such settings are noted below.

Enter a name or short description for the line, if desired.  By default, there is 
no name specified.  A name that contains white space must be quoted.

Set the interface type for the Line.  The default is RS232 for Line 1.
Choices are:



RS232 



RS485 Full-Duplex 



RS485 Half-Duplex 

Select to Enable or Disable Line Termination. The default is Disable.

Select to Enable or Disable the operational state of the Line.  The default is 
Enable.

Set the operational protocol for the Line. The default is Tunnel. Choices are:





Tunnel = Serial-Network tunneling protocol.

Set the Baud Rate (speed) of the Line.  The default is 9600.
Any set speed between 300 and 921600 may be selected: 300, 600, 1200, 
2400, 4800, 9600, 19200, 38400, 57600, 115200, 230400, 921600.  When 
selecting a Custom baud rate, you may manually enter any value between 
300 and 921600.  

Set the Parity of the Line. The default is None.

Set the number of data bits for the Line. The default is 8.

Set the number of stop bits for the Line. The default is 1.

Set the flow control for the Line. The default is None.