TP-LINK TD-W8960N Benutzerhandbuch

 

Figure 4-20 

If your ISP provides an IPoE connection and you want to use an ETH Interface, follow the steps 
below to add a WAN service over a selected ETH interface: 

1.  Add a new ETH interface on the screen of 

. 

2. Click 

the 

 button on the screen Figure 4-8 and the next configuration is similar to IPoE 

over ATM interface (see section 

). The difference is that you have to 

set the 802.1P Priority and 802.1Q VLAN ID on the screen of Figure 4-20 (corresponding 
screen see Figure 4-10). 

If you want to adopt the Bridge service and you need to use an ETH Interface, follow the steps 
below to add a WAN service over a selected ETH interface: 

1.  Add a new ETH interface on the screen of 

. 

2. Click 

the 

 button on the screen Figure 4-8 and the next configuration is similar to Bridge 

over ATM interface (see section 

). The difference is that you have to 

set the 802.1P Priority and 802.1Q VLAN ID on the screen of Figure 4-20 (corresponding 
screen see Figure 4-10). 

) 

The Bridge option only display on the screen of Figure 4-20 when VLAN MUX Mode is selected for 
Connection Mode on the screen of Figure 4-6. 

Choose “Advanced Setup”Æ“LAN”, and you will see the LAN screen (shown in Figure 4-21), the 
section allows you to configure the Router’s LAN ports settings. 

28