E-flite UMX Whipit DLG BNF Basic EFLU3150 Datenbogen

8

Before the fi rst fl ights, or in the event of an 
crash, make sure the fl ight control surfaces 
are centered when the transmitter controls and 
trims are neutral. The transmitter sub-trim must 
be set to zero.
Adjust the linkages mechanically if the control 
surfaces are not centered. Use of the transmitter 
sub-trims may not correctly center the aircraft 
control surfaces due to the mechanical limits of 
linear servos.

 

Make the U-shape narrower to make the connector 
shorter. Make the U-shape wider to make the 
linkage longer.

The table to the right shows the factory settings for 
the control horns. Fly the aircraft at factory settings 
before making changes.

After fl ying, you may choose to adjust the linkage 
positions for the desired control response.

CAUTION: When these are incorrectly 

connected for the pilot’s skill level, unexpected 
aircraft response to controls can result. This can 
cause damage to the aircraft and personal injury.

Increase aircraft visibility by applying included 
decals to the underside of one wing.

1.   Ensure the wing is clean.

2.   Lift a decal from a sheet and carefully apply it 

to the aircraft.

3.   Rub out from the center of the self-adhesive 

decal to remove bubbles.