Brother LK3-B438E MKII Benutzeranleitung
149
ZE-8570,8580
12. REPLACING PARTS
12. ERSETZEN VON TEILEN
12. REMPLACEMENT DES PIECES
12. CAMBIO DE PARTES
12. ERSETZEN VON TEILEN
12. REMPLACEMENT DES PIECES
12. CAMBIO DE PARTES
■ Removal
1. Remove the two screws
1. Remove the two screws
q, and then remove the bed
plate
w.
2. Loosen the set screw
r of the set collar e to release
the cutting pressure of the edge knife
t.
3. Remove the screw
y, and then remove the needle
plate cover
u.
4. Use the accessory Z-shape screwdriver to remove the
screw
i, and then remove the edge knife t.
5. Remove the two screws
o, and then remove the fixed
edge knife
!0.
■ Installation
NOTE:
NOTE:
Either side of the standard fixed edge knife can be
used.
used.
1. Place the fixed edge knife
!0 into the groove in the
needle plate
!1 so that dimensions A and B in the il-
lustration are equal to each other, and then secure it
by tightening the two screws
by tightening the two screws
o.
2. Use the Z-shaped screwdriver to tighten the screw
i
to install the edge knife
t so that it gap between it
and the fixed edge knife
!0 is 0.03 to 0.05 mm.
* If the edge knife
t cannot be installed at a slight
angle, or if it does not cut properly, install the edge
knife
knife
t to the edge knife bracket !2, and then loosen
the two screws
!3 and tilt the edge knife bracket !2
so that the edge knife
t is at a slight angle.
However, if the angle is too large, the blade will
reach the end of its useful life more quickly.
reach the end of its useful life more quickly.
3. Adjust the cutting pressure of the edge knife
t using
the set screw
r of the set collar e. (Refer to page 170.)
4. Install the needle plate cover
u with the screw y.
5. Install the bed plate
w with the two screws q.
o
12-2. Edge knife
1539M
1536M
1538M
q
w
e
r
y
u
i
o
!1
!0
o
o
!0
o
i
t
t
!2
0.03~0.05mm
!2
!3
1627M
!1
!0
Align centers of
grooves
grooves
!0 and !1.
<For optional fixed edge knife>