Trane Gas Unit Heaters Wartungshandbuch

GTND-SVX01B-EN

General Information

Description

The Tubular Gas-Fired Unit Heater is a factory assembled,
power vented, low static pressure type propeller fan unit
heater designed to be suspended within the space to be
heated. THESE HEATERS ARE NOT TO BE CONNECTED TO

DUCTWORK. The designs are certified by ETL as providing
a minimum of 80 percent thermal efficiency, and approved
for use in California. Do not alter these units in any
way. If you have any questions after reading this manual,
contact the manufacturer.

General Safety Information

Important:

This product must be installed by a licensed
plumber or gas fitter when installed within
the Commonwealth of Massachusetts.

•

Installation must be made in accordance with
local codes, or in absence of local codes with the
latest edition of ANSI Standard Z223.1 (N.F.P.A.
No. 54) National Fuel Gas Code.

All of the ANSI and NFPA Standards referred to
in these installation instructions are those that
were applicable at the time the design of this
appliance was certified. The ANSI Standards are
available from the CSA Information Services,
1-800-463-6727. The NFPA Standards are
available from the National Fire Protection
Association, Batterymarch Park, Quincy, MA
02269.

Unit sizes 150–400: These units are designed for
use in airplane hangars when installed in

accordance with ANSI/NFPA No. 409, and in
public garages when installed in accordance
with NFPA No. 88A and NFPA No. 88B.

Unit sizes 30–120: If installed in Canada, the
installation must conform with local building
codes, or in absence of local building codes,
with CAN/CanGa-B149.1 “Installation Codes for
Natural Gas Burning Appliances and
Equipment” or CAN/CanGa-B149.2 “Installation
Codes for Propane Gas Burning Appliances and
Equipment”

. These unit heaters have been

designed and certified to comply with CSA 2.6.

Unit sizes 150–400: If installed in Canada, the
installation must conform with local building
codes, or in absence of local building codes,
with CSA-B149.1 “Installation Codes for Natural
Gas Burning Appliances and Equipment” or
CSA-B149.2 “Installation Codes for Propane Gas
Burning Appliances and Equipment”. These unit
heaters have been designed and certified to
comply with CSA 2.6. Also see sections on
installation in

“Aircraft Hangers,” p. 16

and

“Public Garages,” p. 16

•

Do not alter the unit heater in any way or damage
to the unit and/or severe personal injury or death
could occur!

Figure 1.

Tubular Propeller Unit Heaters

Front view (Unit size 150)

Rear view (Unit size 150)

See

“Identification of Parts,” p. 8

for unit components.