Lide Glass Lid J3500 Benutzerhandbuch

 

19

 

 
The Countryside Model 3502 Fireplace Insert may be installed in a masonry factory built fireplace or 
on a non-combustible floor as shown below.  NOTE:  When installing as a fireplace insert, the unit must 
extend out of the fireplace opening 12” to accommodate access to the circuit board panel, draft slide 
(located on the left side of the insert) and the top front hopper lid (to fill the hopper with fuel). 
 
 
 
 
 
 
 
 
NOTE: The circulation air inlet fins must be inside the room.  Do not put the shroud in front of them. 
 
NOTE: Existing fireplace dampers must be locked in the open position, seal any openings between the 
masonry of the fireplace and the facing masonry.