Lide Glass Lid J3500 Benutzerhandbuch

 

21

 
 
 
Your Countryside Corn/Pellet Stove comes to you with the glass door installed in place, ready for use.  
The glass is surrounded on the edges with a gasket and seated in a glass channel.  It is held in place with 
two (2) clips on the top and two (2) clips on the bottom 
 
REMOVAL OF BROKEN OR DAMAGED GLASS 

 
Open the door and lift off of hinges.  If the door is tight, tap gently on the bottom of the door with your 
hand or rubber hammer.  Lay door down on newspaper with glass clips facing you.  Using a #2 Phillips 
screwdriver, loosen the screws and take off the glass clips.  Remove the broken glass carefully and 
discard. Be careful not to loose the (2) spacer clips located in the bottom corners. 
Check to make sure that the gasket material under the glass is in good shape. You can get this material 
from the factory or from an authorized Countryside reseller if it needs to be replaced. 
Reverse the above procedure for replacing new glass.  When installing the new glass make sure that 
the glass is not sitting on top of any obstruction.  The glass will break when tightening the screws if 
the glass is on the gasket.  Hold the glass toward the top of the door glass channel when tightening. 

 
 
 
 
 
 
 
 
 
 
 
 
 
CLEANING THE GLASS 

 
When the fire is first started, it will produce some smoke.  The smoke might accumulate on the glass 
surface.  Before the fire gets hot, open the door and wipe the glass surface off with a damp rag.  Do not 
touch the surface with your hands.  If after constant use, the glass is dirty; you must clean the glass so that 
it will not become etched with the fly-ash.  When the glass has cooled off, take a damp rag, put a little fly- 
ash from the unit on it and clean the glass.  If this does not clean the glass use a special glass cleaner 
provided by your Countryside reseller.  We have found that Amway crème glass & chrome cleaner 
works real well. 

 
 
 
 
 
 
 
Glass Spacer Clip 
One each side