Alcatel OneTouch L100 - 4G - 100 MBPS Benutzeranleitung

Seite von 16
 
15 
9.  Q:  Sending an SMS failed 
 
A:  Please make sure the SMS center number is correct. 
 
10. Q:  I cannot receive an SMS 
 
A:  Please check whether your SIM/USIM card’s memory is full. 
 
11. Q:  Why can I only save part of the name when adding a new contact? 
 
A:  The SIM/USIM card can only hold 12 SBC characters, and 6 DBC characters. 
 
12. Q:  Does it support roaming? 
 
A:  This depends on the local operator. Please check with your local operator or 
service provider. 
 
 
 
www.sar-tick.com 
This product meets applicable national SAR limits of 2.0W/kg.       
The specific maximum SAR values can be found in the following section of this user 
guide. 
When carrying the product or using it while worn on your body, either use an 
approved accessory such as a holster or otherwise maintain a distance of 5mm 
from the body to ensure compliance with RF exposure requirements. Note that the 
product may be transmitting even if you are not making a phone call. 
CE
Proof  of  compliance  with  international  standards  (ICNIRP)  or  with  European 
Directive 1999/5/EC (R&TTE) is required of all Modem models before they can be put 
on  the  market.  The  protection  of  the  health  and  safety  for  the  user  and  any  other 
person is an essential requirement of these standards or this directive.
 
THIS DEVICE MEETS INTERNATIONAL GUIDELINES FOR EXPOSURE TO RADIO WAVES. 
The USB-Modem is a radio transmitter and receiver. It is designed not to exceed the 
limits  for  exposure  to  radio  waves  (radio  frequency  electromagnetic  fields) 
recommended  by  international  guidelines.  The  guidelines  were  developed  by  an 
independent scientific organization (ICNIRP) and include a substantial safety margin 
designed to assure the safety of all persons, regardless of age and health. 
The radio wave exposure guidelines use a unit of measurement known as the Specific 
Absorption Rate, or SAR. The SAR limit for mobile devices is 2 W/kg.   
Tests  for  SAR  are  conducted  using  standard  operating  positions  with  the  device 
transmitting  at  its  highest  certified  power  level  in  all  tested  frequency  bands.  The