Trane Gas Unit Heaters Katalog

Seite von 69
UH-PRC002-EN
65
Mechanical Specifications
 
Additional Options
Type 409 Stainless Steel Burners
Orifices for Elevations over 2000 feet
Type 409 Stainless Steel Draft Diverter
Summer/Winter Switch
Horizontal Louvers
Horizontal and Vertical Louvers
Side Access Burner Drawer
Allows entire burner drawer to slide out from the side of the unit for service or inspection.
Fan Time Delay Relay
The fan time delay relay delays the fan start until the heat exchanger reaches a predetermined 
temperature. It also allows the fan to operate after burner shutdown, removing the residual heat 
from the heat exchanger. (Recommended on applications that require intermittent fan.)
Field-Installed Accessories
Natural to LP (Propane) Gas Conversion Package (Standing Pilot Only)
LP (Propane) to Natural Gas Conversion Package
High Gas Line Pressure Regulator—Reduces main gas line pressure to a minimum of 7 inches wc 
(water column). Pressure at the jobsite must be specified. The regulator is selected to 
accommodate that specific pressure.
Discharge Nozzles
“Y” Splitter
30° Downward
60° Downward
90° Downward
Drain Pan
Recommended for use with installations on the downstream side of a cooling coil.
Thermostats
Low voltage room thermostat, single-stage
Low voltage room thermostat, two-stage
Low voltage duct thermostat, single-stage
Low voltage duct thermostat, two-stage
Universal tamper-proof guard for all room thermostats
Low voltage room thermostat, single-stage with summer/winter switch
Room thermostat, electronic modulating control
Duct thermostat, electronic modulating control
Override room thermostat, for use with duct thermostat and electronic modulating control.
Separated Combustion Duct Furnaces (model GM)
General
Units are completely factory assembled, piped, wired, and test fired. All units are AGA Certified, 
80 percent efficient and conform with the latest ANSI Standards for safe and efficient performance.