Thermador PH30HS Installationsanweisungen
English 4
Appliance Installation
CAUTION:
Vent unit to the outside of building only.
The hood can be mounted on a wall or suspended from a
cabinet. Both vertical and horizontal discharge are possible
with either mounting method.
cabinet. Both vertical and horizontal discharge are possible
with either mounting method.
Discharge Direction:
The hood is shipped ready for vertical discharge. To
change to horizontal discharge, move the discharge cover
shown in Figure 1 to the top of the hood. The plate is held
in place by four (4) screws.
change to horizontal discharge, move the discharge cover
shown in Figure 1 to the top of the hood. The plate is held
in place by four (4) screws.
Assembly of the Transition:
The supplied transition mounts to the top or rear of the
hood depending on the discharge direction.
hood depending on the discharge direction.
1. Align mounting holes at base of transition with
mounting holes on 1/2” flange located at the top or rear
of the hood, depending on direction of discharge.
of the hood, depending on direction of discharge.
2. Fasten transition to hood using two (2) # 8 sheet metal
screws (included with hood).
3. Seal connection between transition and hood with duct
tape.
4. Remove tape holding damper closed.
See Figure 2 for overall hood dimensions.
* Varies by model.
Note:
Read Remote Control Installation Instructions before
continuing if using this accessory.
Read Remote Control Installation Instructions before
continuing if using this accessory.
Figure 1: Discharge Direction
This opening
is covered for
horizontal
discharge
is covered for
horizontal
discharge
This opening
is covered
for vertical
discharge
is covered
for vertical
discharge
Figure 2: Overall Dimensions
30", 36", 42", 48", 54"*
18"
24", 27"*