Thermador PH30HS Installation Instruction

English 4

Vent unit to the outside of building only.

The hood can be mounted on a wall or suspended from a 
cabinet. Both vertical and horizontal discharge are possible 
with either mounting method.

Discharge Direction:

The hood is shipped ready for vertical discharge. To 
change to horizontal discharge, move the discharge cover 
shown in Figure 1 to the top of the hood. The plate is held 
in place by four (4) screws.

Assembly of the Transition:

The supplied transition mounts to the top or rear of the 
hood depending on the discharge direction.

1. Align mounting holes at base of transition with 

mounting holes on 1/2” flange located at the top or rear 
of the hood, depending on direction of discharge.

2. Fasten transition to hood using two (2) # 8 sheet metal 

screws (included with hood).

3. Seal connection between transition and hood with duct 

tape.

4. Remove tape holding damper closed.

See Figure 2 for overall hood dimensions.

* Varies by model.

Note:
Read Remote Control Installation Instructions before 
continuing if using this accessory.

This opening 
is covered for 
horizontal 
discharge

This opening 
is covered 
for vertical 
discharge

30", 36", 42", 48", 54"*

18"

24", 27"*