Soleus SGCAC08ESE Bedienungsanleitung

 7 

as shown. 

Use adjustment bolt and hex flange nut to complete 
assembly. Choose slot and adjustment bolt hole 
locations that will create a 45 degree angle between 
platform and support brace. Try assembly in the 
window to determine if platform will rest properly, and 
allow proper slope (3/16-inch lower on outside). 

If you are planning to use a siding protection 

board (see Step 5) on the outside of your 
house, hold board in place when testing assembly in 
window. 

a line 8-11/16 inches 

from window jamb. 

If any sash stop protrudes more than 1 

inch from the side window jambs, the 8-11/16-inch 
measurement must be increased accordingly. 
Screen and storm window frames may also require 
adjustments to the measurement. 

on the line with inside 

platform tab pressed against inside edge of window 
track. Using the holes in the platform as a guide, 
mark and drill two 9/64-inch diameter holes. Drill 
holes in either track or stool. 

 

   

CAUTION 

 

Property Damage Hazard—Failure to adhere 
to the following precautions could result in 
damage to window or the air conditioner. Make 
sure the wood stool or window track is securely 
attached to the building construction. Use 
longer screws in sub-framing if necessary.