Soleus SGCAC08ESE Bedienungsanleitung

 9 

between a board 

and a work table, and cut along cutting line with a fine 
tooth saw. Remove any burrs with a file. 
 

to the sides of the AC 

using 3 screws (Item 17) per channel. Start with first 
screw at top of channel. Make sure hook ends of 
channels face toward back of unit. 
 

with the smooth side to the room. Slide panel frame 
assembly into side channels of the AC cabinet. Make 
sure plastic window panel is firmly enclosed on all 
sides by the retainer grooves. 
 

into 2 equal lengths. 

Remove protective backing and apply it to the rear 
side of cabinet side channels, starting just below 
panel frame assembly. Pinch off excess length so 
seal is even with the bottom of the cabinet side 
channel. 

1. Remove the two front retaining screws from the 

front frame. 

2. Press firmly on each side of the metal case close 

to the front, approximately 2/3 of the way down. 

3. While pressing on the sides of the metal case, 

gently pull the front out and lift up to release it 
from the case. 

4. Then remove the four screws from the front frame 

to release the control panel box. 

DO NOT push or pull air direction louvers. 

 

As shown right, it 

should sit on platform assembly so that window panel 
frame, and cabinet side channels are against top and 
side window jambs. (continued)