Patton electronic 1001MC Benutzerhandbuch
Installing NetLink modem cards
19
Model 1001MC Operations Guide
2 • Hardware installation
3. Slide the front rack card into the front chassis slot 14 (see
) until it meets the rear card receptacle.
When that happens, push the front card gently but firmly into the card-edge receptacle of the rear card, it
should click into place.
should click into place.
Figure 6. Rack chassis slot layout (front view)
4. Secure the front rack card using the captive fasteners.
Installing NetLink modem cards
This section contains hardware installation information that affects the following NetLink modems:
•
Model 1092ARC (see section
•
Model 1094ARC (see section
•
Model 1095RC (see section
•
Model 2701RC (see section
•
Model 2707RC (see section
•
Model 2710RC (see section
•
Model 2715RC (see section
•
Model 2088RC (see section
Hardware setup for a Model 1092ARC
The following must be done to configure your Model 1092ARC hardware for use with the Model 1001MC
network management station:
network management station:
•
Connect frame ground to signal ground (see section
)
•
Set the system address (see section
When you are finished, install the Model 1092ARC front card and rear I/O card using the installation proce-
dures in the manual that came with the modem.
dures in the manual that came with the modem.
Configuring frame ground
The Model 1001MC uses an internal bus to communicate with the NetLink modems installed in your system.
The Model 1092ARC rear I/O card must have frame ground (GND) connected to signal GND through a
The Model 1001MC uses an internal bus to communicate with the NetLink modems installed in your system.
The Model 1092ARC rear I/O card must have frame ground (GND) connected to signal GND through a