Patton electronic 1001MC Benutzerhandbuch

Model 3088RC Configuration Slot X page MIB variables description

Model 1001MC Operations Guide 

You can protect individual rack cards from being globally configured by setting the pop-up menu from nor-
mal(0) to protected(1). After you have set the protection option, if you are finished making changes to the cur-
rent rack card, click on the 

 button (located at the right side of the rack card’s row in the table) to save 

the changes.

Setting the protection to normal(0) will enable the rack card to receive 
new configurations through the global configuration command. 

After submitting the protection setting, you must click on the 

 button located on the 

HOME

 page to store 

the configuration changes into memory (see 

for more information).

The circuit ID is a 40-byte string that is stored in non-volatile flash within the Model 1001MC. This string 
can be changed within the 

Configure Cards

 page or from the 

Slot Configuration

 page. After clicking the 

 button to input the string to the management system, you are required to select the 

 button on the Model 1001MC button on the Model 1001MC 

HOME

 page. This will store the 

information into flash making it available after a re-boot or power cycle.

The circuit ID is a 40-byte string that is stored in non-volatile flash within the Model 1001MC. This string 
can be changed from the 

Configure Cards

 web page or from the 

Slot Configuration

 page. 

Click the 

button to input the changes to the management system. After clicking the 

button, you 

are required to select the 

 button on the Model 1001MC button on the Model 

1001MC 

HOME

 page. This will store the information into flash making it available after a re-boot or power cycle.

After submitting the remote circuit ID information, you must click 
on the 

 button located on the 

HOME

 

page to store the configuration changes into memory (see 

on page 228 for more information).

Model 3088RC Configuration Slot X page MIB variables description

This section describes the MIB variables that are available on the Model 3088RC Configuration Slot X page. 
(See 

 on page 193). Starting from the 

HOME

 page, click on the following links: Home (menu) > Config-

ure Cards (menu) > View Rack [rack number] > model3088RC-xxx(x) (in the Local Model Code column).

Displays the address of the NetLink E1-G.SHDSL NTU. The address is defined by the DIP-switch setting of 
S3 and S4 on the rack card.