Patton electronic 1001MC Benutzerhandbuch

Modem Information Rack X

Model 1001MC Operations Guide 

If you want to protect all Model 1095RC, 2701RC, and 2707RC rack cards installed in the current rack from 
being globally configured, select protected(1) from the pop-up menu, then click the 

button. For more 

information about the system configuration feature, refer to section 

Setting the Rack Protection Mode to normal(0) will enable the rack to 
receive new configurations through the global configuration command. 

After you have defined the number of power supplies installed in the rack and the rack protection mode, click 
on the 

 button to save the changes.

Displays the current status of power supply 1 as one of the following:

•

available(0)—The power supply is working normally.

•

down(1)—If the status is shown as down, it means the 1001MC is unable to detect the power supply. This 
status listing will also be highlighted in red.

•

notInstalled(2)—The power supply has not been installed.

Displays the current status of power supply 2 as one of the following:

•

available(0)—The power supply is working normally.

•

down(1)—If the status is shown as down, it means the 1001MC is unable to detect the power supply. This 
status listing will also be highlighted in red.

•

notInstalled(2)—The power supply has not been installed.

Clear Rack X Alarms (clearAlarms)

Click on this button to clear alarms for the current rack. 

The System Log will still display the errors after the 

 button is clicked.

Defines the address of the card. The Model 1001MC will poll the cards using the addresses listed in the 

Card 

Address

 column. If a modem is found with the same address, it will be displayed in that row. The address of 

the card is setup using the DIP-switches on the card. For more information about setting the address of a card, 
please refer to the appropriate NMS version of the manual for the specific NetLink modem. The address is also 
a hyperlink to the 

Slot Configuration

 on page 243 for more informa-

tion). This page can be used to set slot specific information about the card.