Smeg ALFA201XE Benutzerhandbuch

 

 

 

 

 

 

When the oven is used for the first time, it should 
be heated to 200°C for long enough to burn off 
any oily residues left by the manufacturing 
process. 
If you have to carry out any procedures on 
foods, leave the door open for as short a time as 
possible to ensure the temperature inside the 
oven does not drop far enough to impair cooking 
results. 
To avoid unpleasant contact with any steam 
inside the oven, open the door in two stages: 
hold it half-open (about 5 cm) for 4-5 seconds, 
then open it completely. 

 

The inside lights are turned on by turning the thermostat knob. 

 

When the oven is cold, set a preheating temperature of no more than 
200°C. Once the set temperature is reached, wait a few minutes after the 
buzzer sounds or after the pilot light goes out before starting cooking 
processes. 

 
 

At first use, or after a power failure, the time must be set. The display will 

show a flashing icon 

.  

To set the current time, hold down START + STOP together until the 
display stops flashing. 
Now press START to increment the hour display. Once the current hour 
has been set, press STOP to set the minutes and increment them as 
before by pressing the START button. 
When the correct time is set, press the STOP button and the display will 
stop flashing. 

 

After having set the time as described above and pressed the STOP 
button to confirm the setting, the display will show P8.3 (maximum power 
absorption 8.3 kW) if the oven is connected to a three-phase power 
supply, or P5.5 (maximum power absorption 5.5 kW) if the power supply is 
single-phase. 
Press START repeatedly to scroll through the power absorption settings 
available: 
P8.3, P5.5 or P3.0 for three-phase power connection;