DISH Network 6.2 User Manual

3.

Use the NUMBER PAD to enter any number between 1 and 16, 
but not the one you wrote in step 1.

4.

Press POUND (#). If you entered the address correctly, SAT will 
flash three times.

Write down the number you entered in Your Remote Control 
Codes on page 24.

5.

Press RECORD. Make sure the Remote Address you see on 
the System Information screen is the same as the one you 
entered in step 3. If it isn't, the remote cannot control the receiver.

6.

Press SELECT to close the System Information screen.

Your remote has a switch to change the UHF frequency that your 
remote control uses. It comes preset to the A position but you can 
change the setting to the B position to lessen the likelihood of any other 
UHF remote interfering with yours. This feature is available only with 
the DISH Player-DVR 942.

1.

Remove the battery cover from the remote control.

2.

Use a small screw driver or a paper clip to carefully 
change the setting.

3.

Put the battery cover back on the remote control.

4.

Use the SYS INFO button on the front panel to 
open the System Information screen.

5.

Press RECORD on the remote control.

6.

Make sure the System Information screen 
shows the correct band information:

• Switch position A - IR/UHF Pro Band A

• Switch Position B - IR/UHF Pro Band B

All receiver models except the DISH Player-DVR 
942 must use switch position A or else your remote 
control will not work.

62book.book  Page 9  Tuesday, April 4, 2006  1:45 PM