DISH Network 6.2 User Manual
11
6.
Move the highlight to the address for the
Remote Address
as shown below. This is important - if you do not move the
highlight, your remote will change the receiver's
highlight, your remote will change the receiver's
Remote
Address and cause your Remote Control 1 to control the TV2
side of your receiver.
side of your receiver.
7.
Press the RECORD button on the green TV1 remote control you
are setting up. If you get a warning that tells you to pick another
address, continue on to the next step. If no warning pops up, go to
the step 12 of this procedure.
are setting up. If you get a warning that tells you to pick another
address, continue on to the next step. If no warning pops up, go to
the step 12 of this procedure.
8.
On the remote control, press and hold the SAT mode button about
three seconds, until all the mode buttons light up, and then let go
of the SAT button. The SAT mode button will blink.
three seconds, until all the mode buttons light up, and then let go
of the SAT button. The SAT mode button will blink.
9.
Use the number buttons to enter any number from 1 to 16, except
for the address shown for
for the address shown for
.
Write down the number you entered:
10. Press the POUND (#) button. If you entered the address correctly,
the SAT mode button will flash three times.
11. Make sure the System Information screen shows
UHF and
that this address matches the number you entered in step 9.
12. Select Done to close the System Information screen. If
nothing happens, press RECORD, and then select Done.
i
Remote Addrs.
TV Out
UHF
3
5
1
Note: Highlight the
Remote Address (the shaded
area in the graphic above).
62book.book Page 11 Tuesday, April 4, 2006 1:45 PM