Smooth Fitness 9.45TV User Manual

 

 

 

MOTION CONTROL: 
 
Walking belt speed can be increased, decreased or stopped using the Motion 
Control sensors on the handlebars.  To do this follow the instructions below:

 

 

 
 
 

1.  Press the  

  button on the console to switch the motion control 

function on and off: 

 

 

• 

When the LED light is ON the MOTION CONTROL is active. 

• 

When the LED light is OFF the MOTION CONTROL is off. 

 

 
 

2.  After switching on the MOTION CONTROL wave your right hand 

approximately 6 inches above the motion sensor on the right handle 
bar to increase the speed.  The sensor will sound one short BEEP 
per scan and speed up by 0.1 MPH per BEEP.  Holding your right 
hand approximately 6 inches above the right sensor constantly 
results in the sensor sounding one long BEEP per second and 
speeding up by 0.5 MPH per second. 

 

 

 

2.  Use right sensor to speed up. 

3.  Wave you left hand approximately 6 inches above the motion sensor 

on the left handle bar to decrease the speed.  The sensor will sound 
one short BEEP per scan and decrease speed by 0.1 MPH.  Holding 
your left hand approximately 6 inches above the left sensor 
constantly results in the sensor sounding one long BEEP per second 
and decreasing speed by 0.5 MPH per second. 

 

 

 

3.  Use left sensor to slow down. 

4.  Wave both hands approximately 6 inches above both motion 

sensors at the same time.  The sensor will sound two short BEEP 
sounds then stop the belt. 

• 

 

 

4.  Use both sensors to stop belt.