Smooth Fitness 9.45TV User Manual

 

 

 

CLEANING: 
 
Routine cleaning of your treadmill will extend the product's life.  
 

• 

Warning: To prevent electrical shock, be sure the power to the treadmill is OFF and the power cord is unplugged from the 
wall electrical outlet before attempting any cleaning or maintenance.   

 

• 

Important: DO NOT use abrasives or solvents to clean the treadmill.  To prevent damage to the computer, keep liquids 
away and keep it out of direct sunlight. 

 

• 

After each workout:  Wipe off the console and other treadmill surfaces with a clean, water dampened soft cloth to 
remove excess perspiration.   

 

• 

Weekly:  Use of a treadmill mat is recommended for ease of cleaning.  Dirt from your shoes contacts the belt and 
eventually makes it to underneath the treadmill.  Vacuum underneath treadmill once a week. 

 
DECK LUBRICATION: 
 
The walking belt has been pre-lubricated at the factory.  However, it is recommended that the running deck be checked periodically 
for lubrication to ensure optimal treadmill performance.  Your treadmill should not have to be lubricated usually within the first 400 
hours of use.   
 
Every 2 months of operation lift the sides of the walking belt and feel the top surface of the running deck as far as you can reach.  If 
you feel signs of silicone, no further lubrication is required.  If it feels dry to the touch, follow the instructions below. 
 
. To purchase lubricant Kit please contact Smooth Fitness 1-888-800-1167 
To apply lubricant under the walking belt: 
 

1.  Position the walking belt so that the seam is located on top and in center of the walking board. 

 

2.  Insert the spray nozzle into the spray head of the lubricant can. 

 

3.  While lifting the side of the walking belt, position the spray nozzle between the walking belt and the board approximately 6" 

from the front of the treadmill and as far to the center as possible.  Apply the silicone spray to the walking board, moving 
from the front of the treadmill to the rear.  Repeat this on the other side of the belt.  Spray approximately 1/4 bottle 
(supplied with treadmill) each time. 

 
Allow the silicone to "set" for 1 minute before using the treadmill. 

 

 

Spray lubricant from to back.