3M 2250M-iD User Manual

78-8130-6150-0 Rev G 

29

For example:

Figure 1: If the target path is to the right of the 

receiver, and running parallel to the operator, the 

right arrow will display.

Figure 2: If the target path is to the left and in front 

of the operator (not running parallel to the receiver) 

the arrow will point toward the top left side of 

the display.

Figure 3: When the receiver crosses the target path, 

a solid line will appear, instead of arrows, indicating 

the target path and its orientation to the receiver 

handle.

Before marking target path, always use Directional Peak (Dir Pk) or Special Peak (Spl 

Pk) mode to verify location.

C. Special Peak (Spl Pk)

Locate/OK [5] + Cable/Pipe [SK] + Mode [SK] + Spl Pk [SK Toggle]

Special Peak Mode turns on only the peak antenna closest to the ground. Special Peak 

Mode is used in applications such as very deep cables or pipes, or when the signal is too 

weak for directional peak tracing.

Left or Right of Target Path

Directly Over Target Path