Alliance Laundry Systems 000 BTU User Manual
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
18
M414545
POSITIONING THE TUMBLER
The tumbler may be removed from the skid before
moving it to the installation location or it may be moved
while still attached to the skid. To remove tumbler from
the skid, unscrew the four shipping capscrews (one at
each corner) and remove the tumbler from the skid. The
lint panel door will have to be removed in order to remove
the two front capscrews.
moving it to the installation location or it may be moved
while still attached to the skid. To remove tumbler from
the skid, unscrew the four shipping capscrews (one at
each corner) and remove the tumbler from the skid. The
lint panel door will have to be removed in order to remove
the two front capscrews.
NOTE: Do not throw these four capscrews away —
they are the leveling legs.
they are the leveling legs.
Screw the four leveling legs back into the level adjusting
fittings from the top.
fittings from the top.
Slide the tumbler to its permanent location and level.
Keep the tumbler as close to the floor as possible. The
tumbler must rest firmly on the floor so weight of tumbler
is evenly distributed. Tumbler must not rock.
Keep the tumbler as close to the floor as possible. The
tumbler must rest firmly on the floor so weight of tumbler
is evenly distributed. Tumbler must not rock.
LEVELING THE TUMBLER
Each tumbler should be leveled within 1/8 inch (3.2 cm)
from front to rear, and 1/8 inch (3.2 cm) from side to side.
Check front to rear level by rotating the clothes cylinder
until one rib is at the bottom, then place a level on the rib.
Side to side level should be checked by placing a level on
the front and rear of the top panel.
from front to rear, and 1/8 inch (3.2 cm) from side to side.
Check front to rear level by rotating the clothes cylinder
until one rib is at the bottom, then place a level on the rib.
Side to side level should be checked by placing a level on
the front and rear of the top panel.