Alliance Laundry Systems D677I User Manual

Page of 122
Installation
510969
36
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Dryer Exhaust Requirements
Exhaust System Materials
Exhaust system materials are not supplied with the 
unit.
Exhaust duct must be 4 inches (10.2 cm) in diameter 
having no obstructions. Rigid metal duct is 
recommended. Non-combustible flexible metal duct is 
acceptable. Do not use plastic or thin foil ducting, 
because it contributes to poor drying performance and 
collects lint, which can lead to a fire hazard.
Never install flexible duct in concealed spaces, such as 
a wall or ceiling.
DO NOT use sheet metal screws on exhaust pipe joints 
or other fastening means which extend into the duct 
that could catch lint and reduce the efficiency of the 
exhaust system. Secure all duct joints with duct tape or 
pop-rivets.
NOTE: Kits described above are optional exhaust 
system materials available at extra cost.
Figure 26 
A clothes dryer produces combustible lint. 
To reduce the risk of fire and combustion 
gas accumulation the dryer MUST be 
exhausted to the outdoors.
W116
This gas appliance contains or produces a 
chemical or chemicals which can cause 
death or serious illness and which are 
known to the State of California to cause 
cancer, birth defects, or other reproductive 
harm. To reduce the risk from substances in 
the fuel or from fuel combustion, make sure 
this appliance is installed, operated, and 
maintained according to the instructions in 
this manual.
W115
To reduce the risk of fire and the 
accumulation of combustion gases, DO NOT 
exhaust dryer air into a window well, gas 
vent, chimney or enclosed, unventilated 
area, such as an attic, wall, ceiling, crawl 
space under a building or concealed space 
of a building.
W045
To reduce the risk of fire, DO NOT use 
plastic or thin foil ducting to exhaust the 
dryer.
W354
WARNING
Description
Kit P/N
May Be 
Obtained 
Locally
Exhaust Duct 
(4" Dia.)
Not Available
Yes
Flexible Metal Duct 
(4" Dia.)
521P3
Yes
Weather Hoods, with 
hinged dampers (4")
Not Available
Yes
Directional Exhaust 
Kit
528P3
No
Tape
Not Available
Yes
D333I
D335I
D335I
D333I
DO
DON’T