Whirlpool W10385093A - SP Manual

Sensing

Wet

Damp

Cool

Down

Done

Wrinkle

Shield

Steam
Control Lock

Promptly remove garments after cycle has 

completed to reduce wrinkling. If you will be 

unable to remove the load promptly, select the 

Wrinkle Shield option before pressing START/PAUSE  

to add up to 90 minutes of periodic tumbling after the  

end of the drying cycle.

Sensing

Wet

Damp

Cool

Down

Done

Wrinkle

Shield

Steam
Control Lock

You may adjust different settings, depending on whether 

you have selected an Auto Cycle, Manual Cycle, or Steam 

Cycle (on some models). See the “Cycle Guide” for detailed 

information.
NOTE: Not all options and settings are available with all cycles. 

Not all cycles are on all models.
Auto Cycles:

You can select a different dryness level, depending on your 

load, by pressing the button for More, Normal, or Less.  

Selecting More, Normal, or Less automatically adjusts the  

dryness level at which the dryer will shut off. Once a dryness 

level is set, it cannot be changed without stopping the cycle.
Automatic cycles give the best drying in the shortest time.  

Drying time varies based on fabric type, load size, and  

dryness setting.
Manual Cycles:

When you select a Manual Cycle, the  

default time appears in the display.  

Use the More Time s and Less Time t 

buttons to increase or decrease the time 

in 1 minute increments. Press and hold to 

change the time in 5 minute increments. 
The default temperature may be changed by pressing the  

Temperature button until the desired dry temperature is lit. 
You may also adjust the time or temperature on a manual cycle 

at any time while the cycle is running.
Steam Cycles (on some models):

Steam cycles add an extra boost of steam to help reduce 

odors and loosen wrinkles. 
Quick Refresh: Use to reduce odors and light wrinkles from 

small loads of 3-4 items.
Enhanced Touch Up: Use to reduce wrinkles, including from 

loads left in the dryer too long.

Steam model shown

Steam model shown

Sensing

Wet

Damp

If all your loads on all Auto Cycles are consistently  

not as dry as you would like, you may change the default  

settings to increase the default dryness level.
Your automatic drying settings can be adjusted to adapt to 

different installations, environmental conditions or personal 

preference. This change is retained and will affect all of your 

Automatic cycles, not just the current cycle/load. There 

are 3 drying settings, which are displayed using the time 

display:

1  Factory preset dryness level.

2  Slightly drier clothes, 15% more drying time.

3  Much drier clothes, 30% more drying time.

NOTE: The settings cannot be changed while the dryer is 

running or paused. The dryer must be in standby mode (the 

power button is off or only the DONE indicator lit) to adjust 

the default settings.

1.  Before starting a cycle, press and hold the TEMP button 

for 6 seconds. 

2.  Press the TEMP button to select the dryness level 

shown in the time display: 1, 2, or 3. 

3.  Press START/PAUSE to save the new dryness level  

setting. 

Press and hold the START/PAUSE button to begin the cycle.