Whirlpool W10423119A User Manual

Gather the required tools and parts before starting installation.

Flat-blade screwdriver

#2 Phillips screwdriver

Adjustable wrench that 

opens to 1" (25 mm)  or 

hex-head socket wrench 

Wire stripper (direct wire 

installations)

Tin snips (new vent 

installations)

1/4" and 5/16" nut driver 

(recommended)

Utility knife 

 Level

Tape measure

Pliers

Caulking gun and 

compound (for installing 

new exhaust vent)

(Not supplied with dryer)

Parts package is located in dryer drum. Check that all parts  

are included.

noTE: Do not use leveling legs supplied if installing with a 

pedestal or a stack kit.

Use a UL listed power supply cord kit marked for use with  

clothes dryers. The kit should contain:

A UL listed 30-amp power supply cord, rated 120/240 volt 

 

■

minimum. The cord should be type SRD or SRDT and be  

at least 4 ft. (1.22 m) long. The wires that connect to  

the dryer must end in ring terminals or spade terminals  

with upturned ends.
A UL listed strain relief.

 

■

Min. 8" long Torx

®

 T25 

screwdriver  

(for door reversal only) 

® TORX is a registered trademark of Saturn Fasteners, Inc. 

(Not supplied with dryer) 

Refer to your “Use and Care Guide” for information about 

accessories available for your dryer.

Vent clamps

 

■

Vent elbows and ductwork

 

■

Additional parts may be required, depending in your installation. 

Check local codes. Check existing electrical supply and venting. 

Read “Electrical Requirements” and “Venting Requirements” 

before purchasing parts.

Leveling legs (4)

“Y” connector

Short inlet hose

Long inlet hose

Rubber washers