Whirlpool W10573709B Quick Setup Guide

B

F

A

Use where local codes permit connecting cabinet-ground 

conductor to neutral wire. 

Remove center terminal block screw (B).

Direct wire cable must have 5 ft. (1.52 m) of extra length so 

dryer may be moved if needed.

Strip 3

1

/

2

" (89 mm) of outer covering from end of cable. Strip 

insulation back 1" (25 mm). If using 3-wire cable with ground 

wire, cut bare wire even with outer covering. Shape wire ends 

into hooks. 

Connect ground wire (green or bare) (F) of direct wire cable 

under green external ground conductor screw (A). Tighten 

screw.

Place hooked ends of remaining direct wire cable wires under 

outer terminal block screws (hooks facing right). Squeeze 

hooked ends together and tighten screws. Finally, reinsert tab 

of terminal block cover into slot of dryer rear panel. Secure  

cover with hold-down screw. Now, go to “Venting Requirements.”

C

B

Place hooked end of neutral wire (white  

or center) (C) of direct wire cable under  

center terminal block screw (B), hook  

facing right. Squeeze hooked end together. 

Tighten screw.

Place hooked ends of remaining direct wire cable wires under 

outer terminal block screws (hooks facing right). Squeeze hooked 

ends together and tighten screws. Finally, reinsert tab of terminal 

block cover into slot of dryer rear panel. Secure cover with  

hold-down screw. Now, go to “Venting Requirements.”