Whirlpool IES5000RQ0 User Manual

Page of 8
6
Cleaning the Dryer Interior
1. Apply a nonflammable household cleaner to the stained area 
of the drum and rub with a soft cloth until stain is removed.
2. Wipe drum thoroughly with a damp cloth.
3. Tumble a load of clean cloths or towels to dry the drum.
NOTE: Garments which contain unstable dyes, such as denim 
blue jeans or brightly colored cotton items, may discolor the dryer 
interior. These stains are not harmful to your dryer and will not 
stain future loads of clothes. Dry unstable dye items inside-out to 
prevent dye transfer.
Removing Accumulated Lint
From Inside the Dryer Cabinet
Lint should be removed every 2 years, or more often, depending 
on dryer usage. Cleaning should be done by a qualified person. 
From Inside the Exhaust Vent
Lint should be removed every 2 years, or more often, depending 
on dryer usage.
Changing the Drum Light
(on some models)
1. Unplug dryer or disconnect power.
2. Open the dryer door. Locate the light bulb cover on the back 
wall of the dryer. Remove the screw located in the lower right-
hand corner of the cover. Remove the cover.
3. Turn bulb counterclockwise. Replace the bulb with a 10-watt 
appliance bulb only. Replace the cover and secure with the 
screw.
4. Plug in dryer or reconnect power.
TROUBLESHOOTING
First try the solutions suggested here and possibly avoid the cost of a service call...
Dryer Operation
Dryer will not run 
Has a fuse blown, or has a circuit breaker tripped? 
There may be 2 fuses or circuit breakers for the dryer. Check 
to make sure both fuses are intact and tight, or that both 
circuit breakers have not tripped. If the problem continues, call 
an electrician.
Was a regular fuse used? 
Use a time-delay fuse.
Is the dryer door firmly closed?
Was the Start button firmly pressed?
Is a cycle selected?
The dryer will not start in the Wrinkle Guard
®
 position. Move 
the dial past OFF.
No heat
Has a fuse blown, or has a circuit breaker tripped? 
Electric dryers use 2 household fuses or circuit breakers. The 
drum may be turning, but you may not have heat. Replace the 
fuse or reset the circuit breaker. If the problem continues, call 
an electrician.
 For gas dryers, is the valve open on the supply line?
Unusual sounds
Has the dryer had a period of non-use? 
If the dryer hasn’t been used for a while, there may be a 
thumping sound during the first few minutes of operation. 
Is a coin, button, or paper clip caught between the drum 
and front or rear of the dryer?
 
Check the front and rear edges of the drum for small objects. 
Clean out pockets before laundering.
Is it a gas dryer?
The gas valve clicking is a normal operating sound.
Are the four legs installed, and is the dryer level front to 
back and side to side?
 
The dryer may vibrate if not properly installed. See the 
Installation Instructions.
Is the clothing knotted or balled up? 
When balled up, the load will bounce, causing the dryer to 
vibrate. Separate the load items and restart the dryer.
Timer will not advance
Timed or Air Dry - The timer moves slowly and continuously 
for the time setting.
Automatic Drying - The timer moves only when the clothing 
is mostly dry. See “How Automatic Drying Works” in “Starting 
Your Dryer.”