Whirlpool WED9500T User Manual

12. If you live in a hard water area, use of a water softener is 

recommended to control the buildup of scale through the 
water system in the dryer. Over time, the buildup of lime scale 
may clog different parts of the water system, which will 
reduce product performance. Excessive scale buildup may 
lead to the need for certain part replacement or repair.

13. Select a Timed Dry heated cycle, and start the dryer. Do not 

select the Air Only Temperature setting.

■

Controls are set in a running or “On” position.

■

Start button has been pushed firmly.

■

Dryer is plugged into an outlet and/or electrical supply 
is connected.

■

Household fuse is intact and tight, or circuit breaker has 
not tripped.

■

Dryer door is closed.

This dryer automatically runs an installation diagnostic routine at 
the start of its first cycle.

If you receive an L2 code, there may be a problem with your 
home power supply keeping the dryer’s heater from turning 
on. See “Troubleshooting.”

If you receive an AF code, your dryer vent may be crushed or 
blocked. See “Troubleshooting.”

NOTE: You may notice a burning odor when the dryer is first 
heated. This odor is common when the heating element is first 
used. The odor will go away.

WARNING: To reduce the risk of fire, electric shock, or injury to 
persons, read the IMPORTANT SAFETY INSTRUCTIONS before 
operating this appliance.

This manual covers several different models. Your dryer may not 
have all of the cycles and features described.

The following is a guide to starting your dryer. Please refer to 
specific sections of this manual for more detailed information.

1. Clean lint screen before each load. See “Cleaning the Lint 

Screen.”

2. Place laundry in dryer and shut door.

3. Press the POWER button then rotate the dial to select either 

an Automatic or Manual Cycle. The preset settings and drying 
time for the cycle chosen will be displayed.

NOTE: A default time is displayed when an Automatic Cycle 
is selected. During the first few minutes of the drying process, 
the cycle time may automatically vary from the default time 
based on the size and fabric type of the load. Toward the end 
of the drying process, the estimated time display will adjust 
again, showing the final drying time.