Whirlpool W10097001A-SP User Manual

Adjustable wrench that 

opens to 1" (25 mm)  or 

hex-head socket wrench 

Vent clamps

1/4" nut driver 

(recommended)

Utility knife 

 Level

Tape measure

Pliers

Caulking gun and 

compound (for installing 

new exhaust vent)

Parts package is located in dryer drum. Check that all parts  

are included.

Check local codes. Check existing electrical supply and venting, 

and read “Electrical Requirements” and “Venting Requirements” 

before purchasing parts.

Mobile home installations require metal exhaust system 

hardware, available for purchase from the dealer from whom you 

purchased your dryer. For further information, please reference 

the “Assistance or Service” section of the Dryer  

User Instructions.

Leveling legs (4)

If using a power supply cord:
Use a UL listed power supply cord kit marked for use with 

clothes dryers. The kit should contain:

A UL listed 30-amp power supply cord, rated 120/240 volt 

 

■

minimum. The cord should be type SRD or SRDT and be  

at least 4 ft. (1.22 m) long. The wires that connect to the  

dryer must end in ring terminals or spade terminals with 

upturned ends.
A UL listed strain relief.

 

■

A location allowing for proper exhaust installation.  

 

■

See “Venting Requirements.”
A separate 30 amp circuit.

 

■

If you are using power supply cord, a grounded electrical 

 

■

outlet located within 2 ft. (610 mm) of either side of dryer.  

See “Electrical Requirements.”
A sturdy floor to support the total weight (dryer and load) 

 

■

of 200 lbs. (90.7 kg). The combined weight of a companion 

appliance should also be considered.
Level floor with maximum slope of 1" (25 mm) under entire 

 

■

dryer. (If slope is greater than 1" [25 mm], install Extended  

Dryer Feet Kit, Part Number 279810.) If not level, clothes  

may not tumble properly and automatic sensor cycles may  

not operate correctly.

Do not operate your dryer at temperatures below 45°F (7°C). At 

lower temperatures, the dryer might not shut off at the end of an 

automatic cycle. Drying times can be extended.

The dryer must not be installed or stored in an area where it will 

be exposed to water and/or weather.

Check code requirements. Some codes limit, or do not permit, 

installation of the dryer in garages, closets, mobile homes, or 

sleeping quarters. Contact your local building inspector.

The location must be large enough to allow the dryer door to 

open fully.