Whirlpool W10115227C-SP User Manual

© 2012 Whirlpool Corporation 

02/12

All rights reserved 

Printed in U.S.A.

Remove the 4 screws that attach 2 plugs on the left side. 

Transfer plugs to opposite side using the same 4 screws.

Reattach door hinges to dryer door so that the larger hole is 

at the bottom of the hinge.

Close door and check that door strike aligns with door catch. 

If it is needed, slide door catch left or right within slot to 

adjust alignment.

See the Use and Care Guide or visit our website and 

reference “Frequently Asked Questions” to possibly avoid  

the cost of a service call.

NOTE: 2 people may be needed to reinstall door.
Insert screws into the bottom holes on left side of dryer cabinet. 

Tighten screws halfway. Position door so large end of door hinge 

slot is over screws. Slide door up so screws are in bottom of 

slots. Tighten screws. Insert and tighten top screws in hinges.

Take outer door and rotate it 180º and set it back down on 

inner door. Be certain to keep cardboard spacer centered 

between doors. Reattach outer door panel to inner door 

panel so handle is on the side where hinges were just 

removed. Insert 4 door screws.

Remove door strike from dryer cabinet and set aside.

Remove door strike plug. Insert the door strike removed in 

Step 10 into hole and secure with screw. Insert door strike 

plug into original door strike hole and secure with screw.