Whirlpool W10115227B-SP User Manual

Gather the required tools and parts before starting  

installation. Read and follow the instructions provided  

with any tools listed here.

Flat-blade screwdriver

#2 Phillips screwdriver

Wire stripper  

(direct wire installations)

Tin snips  

(new vent installations)

Adjustable wrench that 

opens to 1" (25 mm)  or 

hex-head socket wrench 

Vent clamps

1/4" nut driver 

(recommended)

Utility knife 

 Level

Tape measure

Pliers

Caulking gun and 

compound (for installing 

new exhaust vent)

Parts package is located in dryer drum. Check that all parts  

are included.

Check local codes. Check existing electrical supply and venting, 

and read “Electrical Requirements” and “Venting Requirements” 

before purchasing parts.

Mobile home installations require metal exhaust system 

hardware, available for purchase from the dealer from whom  

you purchased your dryer. For further information, please 

reference the “Assistance or Service” section of the “Dryer  

User Instructions.”

If using a power supply cord:
Use a UL listed power supply cord kit marked for use with 

clothes dryers. The kit should contain:

A UL listed 30-amp power supply cord, rated 120/240 volt 

 

■

minimum. The cord should be type SRD or SRDT and be  

at least 4 ft. (1.22 m) long. The wires that connect to the  

dryer must end in ring terminals or spade terminals with 

upturned ends.
A UL listed strain relief.

 

■

A location allowing for proper exhaust installation.  

 

■

See “Venting Requirements.”
A separate 30 amp circuit.

 

■

Leveling legs (4)

Putty knife