Whirlpool W10115226C User Manual

Put power supply cord through the strain relief. Be sure that 

the wire insulation on the power supply cord is inside the 

strain relief. The strain relief should have a tight fit with the 

dryer cabinet and be in a horizontal position. Do not further 

tighten strain relief screws at this point.

A

B

C

D

Remove the screws from a 3/4" (19 mm) UL listed strain relief 

(UL marking on strain relief). Put the tabs of the two clamp 

sections (C) into the hole below the terminal block opening 

(B) so that one tab is pointing up (A) and the other is pointing 

down (D), and hold in place. Tighten strain relief screws just 

enough to hold the two clamp sections (C) together.

Remove center terminal block screw (B). Remove neutral 

ground wire (E) from external ground conductor screw (A).

A

E

B

B

C

E

Connect neutral ground wire (E) and neutral wire (white or 

center) (C) of power supply cord under center terminal block 

screw (B). Tighten screw.

IMPORTANT: 

A 4-wire connection is required for mobile 

homes and where local codes do not permit the use of 3-wire 

connections.

Power supply cord 4-wire receptacle

(NEMA Type 14-30R):

Go to “4-Wire Power Supply Cord  

Connection” on this page.

Power supply cord 3-wire receptacle

(NEMA Type 10-30R):

Go to “3-Wire Power Supply Cord  

Connection” on page 9.

4-wire receptacle  

(NEMA type 14-30R)

4-prong plug

Spade terminals with 

upturned ends

Ring terminals