Whirlpool CEDC392JQ0 User Manual

Check that you have everything necessary for correct installation. 
Proper installation is your responsibility.

1. Remove the tape that holds the drum to the cabinet. Move 

the drum by hand in a counter-clockwise direction to make 
certain all tape has been removed.

2. Wipe the interior of the drum thoroughly with a damp cloth 

before using the dryer.

Remove parts package from the dryer drum. Check that all parts 
listed were included.

■

1 - cycle control (timer) knob

■

1 - Push to Start button

■

4 - casters

■

2 - cord brackets

■

2 - screws

Check local codes, check existing electrical supply and venting, 
and see “Venting Requirements” and “Electrical Requirements” 
before purchasing parts.

Check location where dryer will be installed. Proper installation is 
your responsibility.

■

A location that allows for proper exhaust installation. See 
“Venting Requirements.”

■

A grounded electrical supply is required. See “Electrical 
Requirements.”

■

4-inch metal exhaust vent is required. See “Venting 
Requirements.”

■

A sturdy floor to support the total dryer weight of 110 lb 
(50 kg).

■

Location must be large enough to fully open dryer door.

■

A level floor with a maximum slope of 1 in. (2.5 cm) under 
entire dryer. Clothes may not tumble properly and automatic 
sensor cycles may not operate correctly if dryer is not level.

Do not operate your dryer at temperatures below 45ºF (7ºC). At 
lower temperatures, the dryer might not shut off at the end of an 
automatic cycle. Drying times can be extended. Do not store
your dryer in a location with year round temperatures below 
45ºF (7ºC).

Install the dryer where it is protected from water and/or weather.

Check code requirements. Some codes limit, or do not permit, 
installation of the dryer in garages, closets, mobile homes, or 
sleeping quarters. Contact your local building inspector.

 To reduce the risk of fire, this appliance MUST 

BE EXHAUSTED OUTDOORS.

■

flat bladed screwdriver

■

level

■

adjustable wrench

■

gloves (optional)

■

tin snips (new vent 
installations)

■

safety glasses (optional)

■

duct tape

■

caulking gun and 
compound (for installing 
new exhaust vent)