Fujifilm FinePix S5 Pro User Manual

164

U SET UP

C Press flash pop-up button to raise built-in flash (note 

that built-in flash must be raised even if [–] is selected 
for the [MODE] under [BUILT-IN]).

D After confirming that camera flash-ready light and 

flash-ready lights for all Speedlights are lit, frame 
photograph, focus, and shoot.

• If [ON] is selected for [MODELING FLASH] under [

 

FLASH/BKT] in the [SET UP] menu (

➝p.165), all 

flashes will emit a modeling flash when the depth-of-
field preview button is pressed. 

• Commander mode can also be used with FV lock 

(

➝p.85).

• Position the sensor windows on the Nikon Speedlights 

where they will pick up the monitor preflashes from the 
built-in flash (take particular care when not using a 
tripod). 

• Be sure that direct light or strong reflections from the 

Nikon Speedlights do not enter the camera lens (in TTL 
mode) or the photocell on the optional Speedlight (AA 
mode), as this may interfere with exposure. To prevent 
the timing flashes emitted by the built-in flash from 
appearing in photographs taken at short ranges, use a 
low ISO sensitivity and small aperture (large f/-number) 
or an Nikon SG-3IR infrared panel for the built-in flash. 
An SG-3IR is required for best results with rear-curtain 
sync, which produces brighter timing flashes. After 
positioning the Speedlights, take a test shot and view 
the results in the camera monitor.

• Although there is no limit on the number of Nikon 

Speedlights that may used, the practical maximum is 
three. With more than this number, the light emitted by 
the other flash units will interfere with performance. All 
Speedlights must be in the same group; flash 
compensation (

➝p.84) applies to all Speedlights. See 

the Speedlight manual for more information.

How to use the SET UP menu (

➝p.138)