VIVOTEK PZ7122 User Manual

Page of 118
 
 
 
 
VIVOTEK - A Leading Provider of Multimedia Communication Solutions
 
User's Manual - 33  
PPPoE (Point-to-point over Ethernet)
Select this option to configure your Network Camera to make it accessible from anywhere as long as 
there is an Internet connection� Note that to utilize this feature, it requires an account provided by your 
ISP�
 
Follow the steps below to acquire your Network Camera’s public IP address�
1� Set up the Network Camera in LAN�
2. Go to Home > Configuration > Application > Server Settings (please refer to Server Settings on page 
    System log so that you will receive a list of system log in TXT file format which contains the Network 
    Camera’s public IP address in your email or on the FTP server�
4. Go to Configuration > Network > Network Type. Select PPPoE and enter the user name and password 
    provided by your ISP� Click 
Save to take effect�
5� The Network Camera starts to reboot�
6� Disconnect the power source of the Network Camera; remove it from the LAN environment to the 
    Internet�
NOTE
► If the default ports are already used by other device connecting to the same router, the Network 
Camera will select other ports for the Network Camera�
► If UPnP
TM
 is not supported by your router, you will see the following message: 
     
Error: Router does not support UPnP port forwarding.
► Steps to enable UPnP
TM
 user interface on your computer:
Note that you must log on to the computer as a system administrator to install the UPnP
TM
 
components�
    
    1� Go to Start, click 
Control Panel, and then click Add or Remove Programs