Philips 0150-0241B User Manual
Philips ProBridge 13 0150-0241B
6 Appendix
6.1 RS-485 Addressing and Connections
The Philips ProBridge (CBR-PB2-PHILIPS) is not an addressable
device and requires no user settings. The device simply acts as an
device and requires no user settings. The device simply acts as an
interpreter, translating the remote telemetry commands into a
format useable by the P/T/Z controller.
format useable by the P/T/Z controller.
Each camera input, whether a fixed camera or a Pan/Tilt/Zoom (P/T/Z) unit, is
connected to a Kalatel unit input. The Kalatel unit has an RS-485 network
address, and so does the P/T/Z camera receiver. This address determines
address, and so does the P/T/Z camera receiver. This address determines
when the telemetry receiver responds to commands sent over the RS-485
data line. Consult the PTZ installation manual for specific instructions on
data line. Consult the PTZ installation manual for specific instructions on
setting these addresses.
The CBR-PB2-PHILIPS can be used in conjunction with multiple
Kalatel units, and/or keypads controlling the domes and the Kalatel
Kalatel units, and/or keypads controlling the domes and the Kalatel
units. Since the ProBridge unit is a terminated device, care should
be used when using this unit in a mixed application.
be used when using this unit in a mixed application.
The RS-485 network is a multi-drop wiring configuration of maximum length
3,000 feet (1000 meters). RJ45 cable and RJ45 connectors are used for
3,000 feet (1000 meters). RJ45 cable and RJ45 connectors are used for
most hookups (see the installation/connection diagram). Some equipment
manufactured by Kalatel may use flying leads, terminal blocks, or other types
manufactured by Kalatel may use flying leads, terminal blocks, or other types
of connections.
Most units have looping RS-485 network connectors. Either socket can be
used. Do not use third-party RS-485 equipment without first consulting
Kalatel Technical Support for information on compatibility with other Kalatel
used. Do not use third-party RS-485 equipment without first consulting
Kalatel Technical Support for information on compatibility with other Kalatel
equipment.
RS-485 Wire Specification
#24 AWG, twisted pair with shield (2-wire).
Less than 16 pF per foot, nominal.
Less than 25 ohms per 100 foot, nominal.
2-wire: Belden 9842
4-wire: Belden 9844
NOTE
NOTE