Monte Carlo Fan Company 5MYR56 User Manual

install cotter pin into cross pin.

Install downrod into yoke.

Raise fan with downrod assembled to the ceil-

ing bracket and hang fan assembly.  Be sure to

rotate the downrod ball so that the notch in the

bracket engages the slot in the ball.

For Canadian installation in both flush and

downrod mode the safety cable must be

installed into the house structure beams using

the 3” lag screws provided.  Make sure that

when the safety cable is fully extended the

leadwires are longer than the cable and no

stress is placed on the leadwires.

Make wire connections to power source using

wire nuts provided.  Make sure that no filiments

are outside of the wirenut. After making the

wire connections, the wires should be spread

apart with the grounded conductor and the

equipment-grounding conductor on one side of

the outlet box and ungrounded conductor on

the other side of the outlet box.

Loosen 2 screws and remove pin with keeper

for downrod, yoke cover and canopy to fit in

yoke of fan.

Thread black, white wire, and safety cable

through downrod

Make wire connections as per above diagram.

Connect the white wire from the fan to the

White or Neutral wire from the power source.

Connect the black wire from the fan to the

Black or hot wire from the power source.

Connect all Green / Yellow wires from the fan,

Downrod and mounting bracket to the Ground

wire from the house.  

Set dip switches on the Remote Transmitter and Remote

Receiver to the same settings.  This must be done so the

units will communcate properly.  If you have other fans you

can set to control from one transmitter by setting both

receivers the same as the transmitter.  If you have more

than one fan with remote.  You can set the dip switches to

different positiosns to have seperate control.

Remote Transmitter Dip swtiches

Remote Receiver Dip switches

Align hole in downrod with hole in yoke and

install cross pin.

Tighten 2 downrod set screws and lock nuts.

Remove switch housing cap by removing 1

screw without key slots and loosening the other

2 screws and twist to remove.