Monte Carlo Fan Company 5MQ60XX User Manual

Insert downrod into motor yoke.

Next, insert clevis pin through yoke

and downrod.

Remove keeper from pin. Remove

pin replace keeper and save.

Thread wire through downrod with

canopy and yoke cover assembled

onto downrod.

Tighten both yoke set screws to fur-

ther secure downrod. 

Secure with cotter pin.

Loosen the 2 set screws in yoke for

downrod to slip into yoke.

Lift mounting neck to mounting Plate

and align screws. 

Secure mounting neck to the mount-

ing plate with four screws to become

a complete mounting bracket.

Carefully lift fan assembly onto mounting

bracket. Rotate fan so that the notch on the

ball engages the ridge in the mounting bracket.

This will allow hands-free wiring. 

Make wire connections to power source using

wire nuts provided.  Make sure that no filiments

are outside of the wirenut. After making the

wire connections, the wires should be spread

apart with the grounded conductor and the

equipment-grounding conductor on one side of

the outlet box and ungrounded conductor on

the other side of the outlet box.

Fan and light kit combinations over 70 lbs, in

both flush and downrod mode the safety cable

must be installed into the house structure

beams using the 3” lag screws,washers, and

lock washers. provided.  Make sure that when

the safety cable is fully extended the lead wires

are longer than the cable and no stress is

placed on the lead wires. 

Safety cable installation

safety

cable

3” lag

screw

lock

washer

washer

For pullchain controls, follow diagram above.

Make sure that all exposed wiring is secured

inside wire nuts. Note: Wires from house may

vary in color and may not include ground wire.

After wiring is conplete, gently push wires into

junction box with wire nuts pointing upward.

Refer to point 3 of safety tips.

House

Fan

Black

White

Green

Black

White

Green(downrod)

Green(Bracket)

Blue