Monte Carlo Fan Company 5MQ60XX User Manual

Install the switch housing using the 4

screws previously removed.

Remove 4 screws and save to install

switch housing. 

Install switch housing plate by twist-

ing plate with key hole slots into

place. Replace screw removed and

tighten the 4 screws securely. 

Connect plug from fan to switch

house plug. 

For control of fan and optional light from wall

location, follow diagram above. NOTE: A profes-

sional electrician is recommended for this type

of installation.

Raise the canopy up and align the

two holes in the canopy with the two

holes in the hanger bracket. Secure

with two  screws provided.

Re-install safety bar removed in

step. 3 by placing safety bar on

screws, sliding into place, and tight-

ening the 2 screws.

Loosen 3 screws with key slots and

remove 1 screw without slot from

motor plate and save screw. 

Install 3 screws and washers per

blade and tighten securely.  Repeat

for all 5  blades

The screws, washers, and motor

pads are pre-installed to the blade

holders. Attach blade assembly to

motor and tighten screws securely.

Remove the steel motor stabilizing

plate and discard.

Remove the double sided tape from

capacitor and stick capacitor to

switch housing.

capacitor