FIELD CONTROLS UV-500C User Manual

Page 4

 

3.  Disconnect the lamp connection, then rotate lamp-mounting knob counter-clockwise and 

pull the lamp out of the unit. (See Figure 10 & 11) 

4.  Remove lamp carefully, by un-plugging the lamp from the lamp-mounting knob. (See 

Figure 12) 

NOTE: When replacing the lamp, always wipe off lamp with the supplied alcohol wipe before 

installing. 

5.  Plug the new lamp onto the lamp-mounting knob.  (See Figure 12) 

6.  Guide the other end of the lamp through the hole in the UV chamber.  (See Figure 11) 

7.  Secure the lamp into position by rotating the lamp-mounting knob clockwise. 

8.  Plug the lamp power leads back into the power connection.  (See Figure 10) 

NOTE:  UV lamps contain a small amount of mercury, like a typical fluorescent lamp. 
According to the EPA’s Universal Waste Rule, these types of lamps may be disposed of into 
household waste. Check with your local waste management authority for local disposal or 
recycling requirements.   

9.  Close the access door and install the access door screw.  (See Figure 8) 

10.  Plug the power cord back into the wall receptacle or restore power to the UV-500C.  

11.  Use the point of a pen or paper clip to press the “reset” button beside the lamp LED.  (See 

Figure 13) 

12.  Lamp LED will turn from “RED” to “GREEN” and the display will say “LAMP: 365 DAYS”. 

1.  Pull the drawer out at the base of the unit and remove the old filter. 

2.  Remove the filter from its plastic bag and place the filter into the tray of the drawer with the 

black carbon facing up. 

3.  Use the point of a pen or paper clip to press the “reset” button beside the filter LED. 

4.  Filter LED will turn from “RED” to “GREEN” and the display will say “FILTER: 90 DAYS”. 

PHONE: 252-522-3031 

FAX: 252-522-0214   EMAIL: 

SALES@FIELDCONTROLS.COM

 

 

WARNING:  Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or
blindness. Never operate the UV-Aire™ Air Purifying System with the UV chamber door open. Avoid touching the glass portion of the lamp 
with your hands. 

Field  Controls,  L.L.C.  warrants  that  the  following  Field  Controls,  L.L.C.  products  sold  hereunder,  shall  be  free  from  defects  in  material  and  workmanship  under
normal use for eighteen (18) months from date of manufacturing by the consumer excepting the provisions numbered below. 
UV-L

AMPS

/B

ULBS

 

Field Controls, L.L.C. warrants that the following Field Controls, L.L.C. products sold hereunder, shall be free from defects in material and
workmanship under normal use for ninety (90) days from date of installation by the consumer excepting the provisions numbered below. 
Provisions: 

1. 

Field Controls shall have no obligation in the event the customer is unable to provide receipt showing the date the customer purchased the product(s)
or accurate date code information. 

2. 

The product must be properly installed, maintained and operated under normal conditions. 

3. 

Field  Controls  shall  not  be  liable  for  any  consequential  and  incidental  damages,  resulting  from  failure  of  a  Field  Controls,  L.L.C.  product,  failure  to
deliver, delay in delivery, delivery in nonconforming condition, or for any breech of contract or duty between Field Controls, L.L.C. and the customer. 

4. 

Field  Controls,  L.L.C.  products  are  often  intended  for  use  in  specific  applications.  Field  Controls,  L.L.C.  makes  no  warranty  if  a  Field  Controls,  L.L.C.
product is used in applications other than intended. 

5. 

Field Controls, L.L.C. makes no warranty of any kind in regard to any other manufacturer’s products distributed by Field Controls, L.L.C. Field Controls,
L.L.C.  will  pass  on  all  warranties  made  by  the  manufacturer  and  where  possible,  will  expedite  the  claim  on  behalf  of  the  customer,  but  ultimately,
responsibility for disposition of the warranty claim lies with the manufacturer.