Vermont Casting 36XDV User Manual

26

4.  Place the log front (A50). Place the two 

underside holes of the log over the two pin 
studs of the bracket located at the front of the 
burner housing. (Fig. 52)

5.  Place the log top right (A52). Place the bot-

tom round hole onto the knob at the right side 
of the rear log. The cross section of the log 
will rest on top of the center right log. (Fig. 53)

6.  Position the log cross over center (A53) by 

locating the bottom rectangular slot of this 
log onto the knob at the center of the front 
log. The other end of the log, with the bottom 
round hole, will be on the knob located on the 
top center of the rear log. (Fig. 53)

�����
���������������
����

Log Front (A50)

LG956

7.  Place the log left top (A54). Place 

the bottom rectangular slot of this 
log onto the knob at the left side 
of the front log. (Fig. 53)

8.  Place large lava rock onto the 

two sides of the burner tray as 
shown in Figure 53.

Log Cross Over 

Center (A53)

�����
����������
����

Log Left Top 

(A54)

Log Top 

Right (A52)

Log Front (A50)

LG958

Lava Rock

Ember Material

Log Rear 

(A49)

Lava Rock

Log Center 
Right (A51)

�����
��������
����

Log Rear 

(B152)

LG948

Ember Material

1.  Place the log rear (B152). Place the two 

underside holes of the log over the two 
pins studs of the rear log bracket. (Fig. 54)