Hearth & Home Technologies TIARAI-CTO User Manual

August 1, 2008

Page  35

Heat & Glo · Tiara I B & Tiara II B · 7010-149M

   From the rear of the appliance, slide the blower 

into the blower housing with the magnetic strips down. The 
blower openings should be at the front.  
 
Plug blower power cord into fan outlet on junction box. 

The GFK-160A blower has been designed to circulate room 
air through the appliance to enhance heat output.

The blower system operates on 120 VAC, 60 Hz power. This is 
available through a receptacle in the factory installed junction 
box on the underside of the appliance.

KIT CONTENTS:  Blower; speed control; lock nut; control 
knob; ground clip; temperature sensor switch; wing nut; 2 
high-temp black wires; 1 high-temp blue wire.  

TOOLS REQUIRED: Philips head screwdriver; 1/2 in. 

 

wrench.

   Compare CONTENTS OF CARTON with the 

actual parts received.  If any parts are missing or damaged, 
contact your dealer before starting installation.  Do not install 
a damaged blower kit.

   Attach grounding clip supplied with the kit to the 

blower housing.  Attach ground wire to grounding clip.

   Remove valve access cover from back of 

appliance by removing the three screws indicated.

   Slide temperature sensor switch/bracket assembly 

onto the 10-32 screw located on the left underside of the 
appliance.  Secure the bracket assembly with the wing nut 
provided.

Disconnect the two wire ends connected together on the 
junction box.  Connect female end to one side of temperature 
sensor switch.  

Connect one end of the black wire provided with the kit to the 
remaining wire end on junction box.  

Feed loose ends of the black and blue wires through the 
orange grommet in fan housing.