Hearth & Home Technologies SL-750TV-D User Manual
Heat & Glo • SL-550 / 750 / 950TV-D • 2053-985 Rev. H • 9/06
10
C. Clearances
Figure 3.2 Clearances to Combustibles
C
B
D
A
Fire Risk.
•
Construct chase to all clearance specifi cations
in manual.
•
Locate and install appliance to all clearance
specifi cations in manual
Fire Risk.
Odor Risk.
• Install appliance on hard metal or wood surfaces
extending full width and depth of appliance.
• Do NOT install appliance directly on carpeting, vinyl, tile
or any combustible material other than wood.
• Do NOT place furniture or any other combustible household
objects within 36 inches of the appliance front.
B. Constructing the Appliance Chase
A chase is a vertical boxlike structure built to enclose the
gas appliance and/or its vent system. Vertical vents that run
on the outside of a building may be, but are not required
to be, installed inside a chase.
gas appliance and/or its vent system. Vertical vents that run
on the outside of a building may be, but are not required
to be, installed inside a chase.
Construction of the chase may vary with the type of building.
These instructions are not substitutes for the requirements
of local building codes. Local building codes MUST be
checked.
These instructions are not substitutes for the requirements
of local building codes. Local building codes MUST be
checked.
Chases should be constructed in the manner of all outside
walls of the home to prevent cold air drafting problems.
The chase should not break the outside building envelope
in any manner.
walls of the home to prevent cold air drafting problems.
The chase should not break the outside building envelope
in any manner.
Walls, ceiling, base plate and cantilever fl oor of the chase
should be insulated. Vapor and air infi ltration barriers
should be installed in the chase as per regional codes for
the rest of the home. Additionally, in regions where cold
air infi ltration may be an issue, the inside surfaces may be
sheetrocked and taped for maximum air tightness.
should be insulated. Vapor and air infi ltration barriers
should be installed in the chase as per regional codes for
the rest of the home. Additionally, in regions where cold
air infi ltration may be an issue, the inside surfaces may be
sheetrocked and taped for maximum air tightness.
To further prevent drafts in cold climates, the fi restops
should be caulked with high temperature caulk to seal gaps.
Gas line holes and other openings should be caulked with
high temp caulk or stuffed with unfaced insulation. If the
appliance is being installed on a cement slab, a layer of
plywood may be placed underneath to prevent conducting
cold up into the room.
should be caulked with high temperature caulk to seal gaps.
Gas line holes and other openings should be caulked with
high temp caulk or stuffed with unfaced insulation. If the
appliance is being installed on a cement slab, a layer of
plywood may be placed underneath to prevent conducting
cold up into the room.
G
I
H
E
F
J
Models
A
B
C
D
E
F
G
H
I
SL-550TV-D
Inches
10
33
16-1/4
37
31
0
0
1/2
1/2
mm
254
838
413
940
787
0
0
13
13
SL-750TV-D
Inches
10
38-1/4 16-1/4
42
31
0
0
1/2
1/2
mm
254
971
413
1067
787
0
0
13
13
SL-950TV-D
Inches
10
42-1/4 16-1/4
49
31
0
0
1/2
1/2
mm
254
1073
413
1245
787
0
0
13
13
WARNING
WARNING