Hearth & Home Technologies SL-750TV-D User Manual

25

Heat & Glo  •  SL-550 / 750 / 950TV-D  •  2053-985 Rev. H  •  9/06

Remove shipping materials from inside or underneath the 
fi rebox.

•  Remove the log pack and hood, if applicable.

•  Bend top retaining tab of grate shipping support into 

vertical position (see Figure 12.1).

•  Lift grate slightly upward with one hand so that the grate 

clears the support.

•  Slide shipping support to side, remove and discard.

•  Lower grate onto refractory.

Shock or fi re risk.
Use ONLY optional accessories approved for 
this appliance.

•  Using non-listed accessories voids 

warranty.

•  Using non-listed accessories may result in 

a safety hazard.

•  Only Hearth & Home Technologies 

approved accessories may be used safely.

Explosion  Risk.

•  Follow ember placement instructions in 

manual.

•  Do NOT place embers directly over 

burner ports.

•  Replace ember material annually.

Improperly placed embers interferes with proper burner 
operation.

Ember material is shipped with this gas appliance. To place 
the ember material:

•  When placing Glowing Embers

®

 

onto the burner care 

should be taken so that the ports are not covered. 
Place the dime-size ember pieces about 1/2 inch apart 
near port holes in burner top, but not on or in between 
the ports. For best performance do NOT place embers 
on  ports at rear of burner (see Figure 12.2). Failure to 
follow this procedure will likely cause lighting and sooting 
problems.

•  Save the remaining ember materials for use during 

appliance servicing. The embers provided should be 
enough for 3 to 5 applications.

Clean/vacuum any sawdust that may have accumulated 
inside the fi rebox or underneath in the control cavity.

Install approved accessories per instructions included with 
accessories. See Service Parts List for appropriate acces-
sories. Refer to Section 16.