Hearth & Home Technologies 5100I-NL-B User Manual

Page 1

September 1, 2008

R 

438-0380D

The 5100-I Insert comes standard with 2 blowers, installed

at the factory with the power cord on right side of insert (as

you face the unit). Do not route the power cord under or in

front of appliance.

The power cord can also be installed on the left side. Follow 

instructions below.

Shock hazard.

•  Do NOT remove grounding prong from plug.

•  Plug directly into properly grounded  prong 

receptacle.

•  Route cord away from appliance.

•  Do NOT route cord under or in front

of appli-

ance.

Snap Disc

Snap Disc 

by-pass 

switch

Speed Control 

(Rheostat)

Right Blower 

Left Blower 

Red 

Connecto

r

Blue 

Connector

White wire into Red Connector

Black wire into Blue Connector

Green grounding wire

Grounding 

screw

Green 

grounding wire

Blower cord

Black wire

White wire

Strain Relief

Bottom of grille

Top of grille

Back view of grille

Blower cord attached to 

right side of grille.

Remove button plug 

Grounding screw

Back view of left 

side of grille

Bottom of grille

Top of grille

1.

2.  Remove the grille following instructions on

.  Unplug the blower cord wires from the wire harness.
4.  Remove green grounding wire from grounding screw.
5.  Using a pair of pliers, squeeze the strain relief and remove  

the blower cord wires and strain relief from the grille.

6.  Locate the wire harness wires tucked up under the ash-

catcher on the left side of the appliance. Cut the zip tie

that is holding the wires in place.

7.  Remove the button plug from the left side of grille. Thread

the  blower  cords  wires  through  the  hole  and  snap  the

strain relief in place.

8.  Attach grounding wire to ground screw.
9.  Connect the white blower cord wire to the red connector

on the wire harness.

10. Connect the black blower cord wire to the blue connec-

tor on the wire harness.

11. Tuck the wire out of the way of the blower motor.
12. Re-install grille.