Enviro EG31-118 User Manual

Secondary Installation

RICK

ANEL

NSTALLATION

Caution: Use only the type of ember material supplied with this fireplace. Due to the irregular

size of the ember material, there may be more than required. Use of other foreign materials

on the burners may create dangerous conditions.
If over time, through cleaning and servicing, these embers require replacement , contact your nearest

Enviro dealer.

Remove the glass door and the log set. Remove

the burner tray by undoing the hold-down screws

located in the center of the pan burner and sliding

the assembly to the left, then up.
Gently pull right brick side panel inward from the

bottom back. Pull towards the back then out,

freeing it from the front retainer.
Caution: The pilot may damage panel. Remove

left side panel in the same fashion.
To install, insert front edge of brick panel into the

retainer and very gently move panel forward and

out until flush against firebox side.

Figure 31: Focus Log Placement Complete.

Figure 32: Focus Log Set Burning.

Figure 33: Brick Panel Installation.

IMPORTANT: Upon the first light

up after installing logs and embers,

watch for ignition to ALL burner

ports. If a long delay is noted wait

for the appliance to cool down:

• Open the front door of the

appliance

• Carefully reposition the embers,

making sure that the burner ports

are not plugged or blocked.